Single flat spot with a constant radius tail rocker.  Flat Spot #1 is replaced with a constant radius tail rocker for a slightly more forgiving ride than the more advanced 4 and 5 stage rockers.

Dual flat spots with traditional tip rocker.  Stability is achieved with a longer forebody flat spot length than the 5-stage and pre-turn rotation is controlled via bevel design.

Dual flat spots and extremely progressive tip rocker stage.  Flat spot #1 equals speed off the buoy.  Flat spot #2 equals the stable platform the skier balances on back to the wakes.  The progressive tip rocker mimics an extra long flat spot for stability, but a continuous rocker for pre-turn rotation.

A blend of carbon fiber and fiberglass specifically combined to control the rebounding nature of the ski. Provides skiers consistent turns and smooth acceleration.

100% carbon fiber laminates.

Continuous radius rockerline provides a deep stable ride that shuts down speed and drops in when the skier is ready to turn.

Constant concave radius connects the bottom bevels on each side.  Less aggressive edge angle and physical body fatigue.

By reducing the overall taper in the ski, we create a wider tail profile than traditional design.

Traditional fiberglass construction.

Small rails to each side of the concave from the heel of the front foot forward.  Behind the skier’s front foot heel the ski transforms into edge-to-edge concave design. Allows the ski to roll up on a higher edge angle and pulls the forebody of the ski into the water for maximum angle creation and maintenance.

Hand built at the world’s finest water ski factory in Redmond, WA.

Increasing the overall surface area of the ski enhances performance at slower speeds.

By increasing the overall taper in the ski, we create a narrower tail profile than traditional design.

Traditional ski core construction.  Made in the USA.

The most dynamic core material available.  Each core is machined to exact tolerances at the HO Factory in Redmond, WA.

Fully adjustable fin box, machined to the most exacting tolerance.  Set screw adjustability. Syndicate Team designed, tested and proven.

Fore & aft fin blade adjustability.

Proprietary construction technique connects the top and bottom ski laminates for an increased torsional flex pattern.  Result is an increase in cross-course speed and directional stability.

Edge-to-Edge concave design with a boat hull inspired V-Bottom along the concave’s centerline.  Increased tracking and stability for aspiring skiers.