Ski, Fin & Boot Settings
2023 Ski Fin/Boot Factory Settings Guide
2022 Ski Fin/Boot Factory Settings Guide
2021 Ski Fin/Boot Factory Settings Guide
2020 Ski Fin/Boot Factory Settings Guide
2019 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2018 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2017 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2016 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2015 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2014 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2013 SKI FIN/BOOT FACTORY SETTINGS GUIDE
2012 SKI FIN/BOOT FACTORY SETTINGS GUIDE
Syndicate Hardshell Release Chart
This Chart will help you properly set the Release Tenision on your Syndicate Hardshell.
MAX BOOT INSTRUCTIONS
Just follow three simple steps for correctly mounting your MAX boots to your waterski. For the complete set of instructions, as well as, information on your lace management system, click the link below.
MAX ADAPTER PLATE
The HO MAX Adapter Plate Kit allows the user to convert a DirectConnect skiboot for use on a conventional hole pattern ski. MAX SkiBoot Adapter Plate kits are designed to work with freeMAX and xMAX boots ONLY. Ensure you have the correct size plate {size 4-8,size 7-11,or size 10-15) that matches with the size of boot that you have. Ensure that you have the correct plate type (front or rear) for the location you are installing the boot.
LACE REPLACEMENT KIT
1. Measure the old lace for proper length and trim the replacement lace to the same length. 2. If replacing upper zone lace or vMAX lace,first thread lace through lace snap.The next step for any HO MAX SkiBoot lace is to thread the lace through the lace lock.Thread lace through lace guides on boot.Thread ends of lace through lace splice. 3. Tie off ends of lace with secure knots.